Case IH AFX8010 — ELECTRICAL POWER SYSTEM

DISTRIBUTION SYSTEMS - ELECTRICAL POWER SYSTEM SPEED AND POSITION SENSORS Most of the speed and position sensors used on the AFX combine are a 2-wire sensing device designed to work with a switching amplifier circuit in the module the sensor is attached to. The operation of this sensor is similar to that of a variable resistor, which changes its impedance as metal approaches the sensor. When no metal is being sensed, the sensor is in a low impedance state. When metal approaches the sensor, the impedance increases. The varying impedance results in a current flow change that the module detects, and converts into a frequency for speed sensing or position monitoring.

40011026 39 When installing a new sensor, adjust the sensor to obtain a clearance of 3 mm (1/8 ) to the target metal. A.30 / 5X