Case IH AFX8010 — USER PLATFORM

BODY AND STRUCTURE - USER PLATFORM POWER SEAT SYSTEM DIAGNOSTIC TESTS NOTE: The batteries must be fully charged and all connections clean and tight. Use a multimeter (DVOM) for these tests. For battery testing and service, see the battery section in the service manual. DO NOT use a self-powered test light for any of these tests. Use of a self-powered test light can cause damage to components in this system. CAUTION WARNING Before performing any of the electrical tests, be sure all operating controls are in neutral or park lock position. This will eliminate accidental movement of the machine or start-up of power driven equipment.

A - SEAT SYSTEM POWER AND GROUND SUPPLY TEST B - HEIGHT ADJUSTMENT CIRCUIT TEST E.34 / 6 Test Point Good Reading Possible Cause of Bad Reading 1 Check for 12 volts at the Seat Pump Motor M26 connector X313 (pin A). 12 volts If good reading, the wiring has good continuity. Open circuit 80 (OR) between Fuse F16 and Seat Pump Motor M26 connector X313 (pin A). 2 Check for 12 volts between Seat Pump Motor M26 connec- tor X313 (pin B) and Seat Adjust Switch S45 connector X312 (pin 1). 12 volts If good reading, go to next test point. Open circuit between Seat Pump Motor M26 connector X313 (pin B) and Seat Adjust Switch S45 connector X312 (pin 1).

3 Check the resistance between Seat Adjust Switch S45 connec- tor X312 (pin 2) and Ground. Open Seat Adjust Switch S45 during measurement. Less than 1 ohm. If good reading, the wiring has good continuity. If the resistance is less than 1 ohm with the switch open, or greater than 1 ohm with the switch closed, replace the Seat Adjust Switch S45. Test Point Good Reading Possible Cause of Bad Reading 1 Press Seat Adjust Switch S-45 to up position. Seat Pump Motor M-26 runs. If compression runs but seat does not adjust, check for air leakage. Go to next step. Power and ground supply. Seat Pump Motor M-26. Perform Test A - Seat System Power and Ground Supply Test, steps 1-3 and 6-8.

If you did not find any condition, replace Seat Pump Motor M-26. 2 Press Seat Adjust Switch S-45 to down position. . Air is released. System OK. Power and ground supply. Seat Solenoid. Perform Test A - Seat System Power and Ground Supply Test, steps 4/5 and 9/11. If you did not find any condition, replace Seat Solenoid.