BODY AND STRUCTURE - USER PLATFORM POWER MIRROR SYSTEM DIAGNOSTIC TESTS NOTE: The batteries must be fully charged and all connections clean and tight. Use a multimeter (DVOM) for these tests. For battery testing and service, see the battery section in the service manual. DO NOT use a self-powered test light for any of these tests. Use of a self-powered test light can cause damage to components in this system. CAUTION WARNING Before performing any of the electrical tests, be sure all operating controls are in neutral or park lock position. This will eliminate accidental movement of the machine or start-up of power driven equipment.
A - MIRROR ADJUST SWITCH TEST E.34 / 20 Test Point Good Reading Possible Cause of Bad Reading 1 Turn the Key Switch S-02 ON with the engine OFF. Check the voltage at Mirror Adjust Switch S-27 connector X126 (pin H). 12 volts If good reading, go to test point 3. Open circuit 274 (OR) or 79 (OR) between Fuse F09 and Mirror Adjust Switch S-27 (pin H). Check in-line connector X002 (pin 8) for connection. Short to ground in circuit 274 (OR) or 79 (OR). A short to ground will blow Fuse F09. Mirror Adjust Switch S-27. Go to next test point. 2 Disconnect the Mirror Adjust Switch S-27 connector X126. Check the voltage at (pin H). 12 volts If good reading, Go to next test point.
Open or short circuit 274 (OR) or 79 (OR) between Fuse F09 and Mirror Adjust Switch S-27 connector X126 (pin H). 3 Check the resistance on circuit 949 (BK) between Mirror Adjust Switch S-27 connector X126 (pin A) and ground. Less than 1 ohm If good reading, go to next test point. Open circuit 949 (BK) between Mirror Adjust Switch S-27 connector X126 (pin A) and ground. 4 Set Mirror Adjust Switch S-27 selector to Left mirror. Hold Mirror Adjust Switch S-27 in “IN” position. Check the voltage at Mirror Adjust Switch S-27 connector X126 (pin C). 12 volts If good reading, go to next test point. Mirror Adjust Switch S-27. Short to ground which affects circuit 961 (GY).
Check the X036 in-line connector (pin 25) for connection. A short to ground will blow Fuse F09. 5 Hold Mirror Adjust Switch S-27 in OUT position. Check the voltage at Mirror Adjust Switch S-27 connector X126 (pin B). 12 volts If good reading, go to next test point. Mirror Adjust Switch S-27. Short to ground which affects circuit 959 (WH). Check the X036 in-line connector (pin 23) for connection. A short to ground will blow Fuse F09. 6 Hold Mirror Adjust Switch S-27 in DOWN position. Check the voltage at Mirror Adjust Switch S-27 (pin D). 12 volts If good reading, go to next test point. Mirror Adjust Switch S-27. Short to ground which affects circuit 958 (WH).
Check the X036 in-line connector (pin 22) for connection. A short to ground will blow Fuse F09.