DISTRIBUTION SYSTEMS - ELECTRICAL POWER SYSTEM CCM POWER AND GROUND SUPPLIES Each CCM module has two main power supplies. Keep Alive power is supplied to the module at interior connector pin 1, while the main power supply is provided from the key switch at the interior connector pin 4. The module will shutdown if the voltage drops below 9V or exceeds 18V on either of these two circuits. Key switch power is also used to supply the 5V and 8V regulators for voltage outputs to sensors and potentiometers. Each CCM module has three main ground wires to provide a ground path for all sensors and most valve outputs.
These three ground wires are linked together internally, but provide a solid ground path for the module. The module may continue to function if one or two of these ground wires are broken, but sensor reading and other functions may become erratic. Some circuits on the CCM’s provide their own power supply through the engaging switch. This ensures that if power is ever lost through the switch into the module, the output from the module is immediately disengaged. These circuits are the ground speed hydrostat circuit (power supplied through the S22 Neutral switch), thresher engage and feeder engage circuits.
H-bridge circuits in the modules are used to power high current draw components, such as motors and actuators, and have their own dedicated power supplies and grounds, as listed in the charts below.
CCM1 A.30 / 5AB Power Supply Ground Components Affected X018 pin 1 (F39) Keep Alive power X018 pin 4 (F38, key switch) Main power; all potentiometers, speed & position sensors X018 pin 8, X019 pins 12 & 18 Main module grounds X020 pins 29 & 30 (F22) X020 pins 9 & 10 Shoe Leveling Actuator M--03 X020 pin 7 (F24) X020 pin 16 None X019 pin 11 (F24) X019 pin 3 Concave Clearance actuator M--04 Grain Bin Covers actuator M--12 X019 pin 2 (F43) Chaff Spreader valve L--28 Head Raise L--11 Head Lower L--12 Cleaning Fan Valve L--44 X019 pin 9 (F43) Backup Alarm H--08 Brake Limiting Valve L--32 Rear Wheel Assist valve L--26 X020 pin 11 (F44) Head Tilt CW L--18 Head Tilt CCW L--19 2 Speed Powered Rear Axle L--54/L--55 Header Height Accumulator L--06 Feeder Ring to Frame Brake L--50