Case IH AFX8010 — USER PLATFORM

BODY AND STRUCTURE - USER PLATFORM Description The horn circuit is shown with the horn activated (control stalk pushed inward, toward the steering column). Wiring harness -- Electrical schematic frame 36 (A.30.A.88 -- C.20.E.36) Power is supplied to the Horn Switch at all times. The Horn Switch is integrated into the Road Light Switch. When the operator closes the Horn Switch contact, current flows through the Horn Switch to operate the horn. Current flows from the positive (+) battery terminals, and through the start relay (if equipped), to the fuse panel located inside the cab of the combine. Current travels across the fuse panel buss bar to fuse F51.

Current passes through fuse F51 to connector X256 pin 8. When the horn portion of the road light switch (S26) is pushed inward to the “ON” position, current crosses from pin 8 to pin 9. Current exits pin 9 of connector X256 to connector X004 pin 18. Current passes through connector X004 to connector X172 pin 1. Current passes through the connector to the horn. The ground path to the horn travels from connector X172 to the front frame ground location #2. This causes the horn to operate. HORN SYSTEM CIRCUIT TROUBLESHOOTING Before troubleshooting the Horn System, make sure that the following operating conditions are met: B. Transmission is in neutral or park. C.

Check all connectors for full installation, loose, corroded, pushed out or bent terminals. A. The batteries are fully charged, and all connections are clean and tight. D. Verify that fuse F51 is not blown. HORN NOTE: The batteries must be fully charged and all connections clean and tight. Use a multimeter (DVOM) for these tests. E.34 / 31 Symptom Possible Cause Reference/Test Horn does not operate Horn Horn System Circuit Test Circuit Horn System Circuit Test Road Light Switch Horn System Circuit Test, test points 1 thru 3.