Case IH AFX8010 — ELECTRICAL POWER SYSTEM

DISTRIBUTION SYSTEMS - ELECTRICAL POWER SYSTEM CCM INSTALLATION 1. Inspect the gaskets that seal the connector slots in the cab floor for signs of deterioration, replace as required. t 2. Place the CCM mounting studs through the floor of the cab. Connect the appropriate connector, 1, to the CCM. Tighten captured screw, 2, to secure connector to CCM. 3 1 2 10004693 53 3. Install lock washers and thread nuts, 1, onto mounting studs of CCM. Tighten nuts to standard torque. 4. Inspect the seals on the connectors, clean or replace as required. 2 5. Install the connector with the corresponding decal on the underside of the cab floor.

Thread in captured screw of connector, 2, and tighten to standard torque. 1 1 6. Fold protective boots, 3, around connectors. 3 50032237 SOFTWARE INSTALLATION 54 IMPORTANT: The CCM must be loaded with software. Refer to the AFX Combine Electronic Service Tool User’s Guide for software download instructions. INSTRUCTIONAL SEAT INSTALLATION 1. Tighten the seven screws that secure the base of the instructional seat to the cab frame. 2. Insert the storage box, 3. 1 3. Slide seat onto the 4 bolts by pushing the seat back and downward against the rear of the cab. Make sure the top two bolts fit into the notches on the seat back. 3 4. Tighten two bolts, 2, at the bottom of the seat back. 2 5.

Release the strap, 1, on the seat cushion. 50021851 55 A.30 / 5AF