TOOL POSITIONING - LIFTING NOTE: The sense resistor in the module for the Header Raise/Lower Current Sense circuit is easily damaged as a result of excessive current draw or a short to high voltage. 6. Turn the key switch to the ON position. Use the Universal Display Plus "DIAG" screen controls to manually power the header raise valve. Use a multimeter to check for 12 volts between connector X022 pin 4 and chassis ground. A. If 12 volts is not present, there is an open circuit in the main frame (MF) harness between connector X022 pin 4 and connector X019 pin J2-4 wire 1112 white. Locate the open and repair. 7.
Visually inspect the harness and connectors for damage, bent or dislocated pins, corroded terminals or broken wires. B. If 12 volts is found, continue with Step 9 . A. If no damage is found, erase the fault code and continue operation. 9706 1 27/05/2004 G.10.A / 15