TOOL POSITIONING - LIFTING 6. Disconnect connector X032 and connector X007 . Use a multimeter to check for continuity between connector X032 pin 1 and connector X007 pin 15. A. If continuity is found, continue with Step 7 . B. If no continuity is found, there is an open circuit in the feeder (FE) harness between connector X032 pin 1 and connector X007 pin 15 wire 738 yellow. Locate the open and repair. 7. Carefully disconnect connector X020 from the bottom of CCM1 module. Use a multimeter to check for continuity between connector X007 pin 15 and connector X020 pin J3-24. A. If continuity is found, the open is in the sensor. Replace the sensor. B.
If no continuity is found, there is an open circuit in the front frame (FF) harness between connector X007 pin 15 and connector X020 pin J3-24 wire 738 yellow. Locate the open and repair. 8. Visually inspect the harness and connectors for damage, bent or dislocated pins, corroded terminals or broken wires. A. If no damage is found, erase the fault code and continue operation. 9706 1 27/05/2004 G.10.A / 46