Case IH AFX8010 — FEEDING Header feeding

CROP PROCESSING - FEEDING Header feeding A. If there is greater than 5 volts on the pink wire, there is a short to high voltage on the 5 volts supply wire. The fault code E0167-03 - CCM2 J3 5V Reference should be displayed in the Universal Display Plus "ERROR" screen. Correct that fault code condition, and then return to step 1 to determine if this fault condition has been corrected. B. If the voltage is 5 volts , continue with Step 3 . 3. Disconnect the header type module connector X435. Locate the wire 750 blue in the connector using the following table: Use a multimeter to check for continuity between connector X435 wire 750 blue and chassis ground. There should be continuity to ground.

A. If there is no continuity to ground, . continue with step 4 . B. If there is continuity to ground, continue with Step 4 . 4. Disconnect the header (HH) harness to feeder (FE) harness connector X032 . Use a multimeter to check for continuity between the feeder (FE) harness end of connector X032 pin 13 and chassis ground. There should be continuity to ground. A. If there is continuity to ground, there is an open circuit in the header (HH) harness between connector X032 and connector X435 wire 750 blue. Locate the open and repair. B. If there is no continuity to ground, continue with step 5 . 5. Disconnect the feeder (FE) harness to front frame (FF) harness connector X007 .

Use a multimeter to check for continuity between the front frame (FF) harness end of connector X007 pin 13 and chassis ground. There should be continuity to ground. A. If there is continuity to ground, there is an open circuit in the feeder (FE) harness between connector X032 and connector X007 wire 750 blue. Locate the open and repair. B. If there is no continuity to ground, there is an open circuit in the front frame (FF) harness between connector X007 and connector X017 pin J3-18 wire 750 blue or 766 blue. Locate the open and repair. 6. Disconnect the header type module connector X435. Locate the wire 1116 yellow in the connector using the following table:

Use a multimeter to check for voltage between connector X435 wire 1116 yellow and chassis ground. There should not be any voltage. A. If there is no voltage, the module has failed internally. Replace the header type module. B. If there is voltage (> 4.72 volts ), continue with Step 6 . 9711 1 27/05/2004 K.25.D / 16 Header Type Connector X435 Ground Wire Corn header Pin F Grain header Pin F Draper header Pin E Pick up header Pin A Programmable header Pin A Header Type Connector X435 Signal Wire Corn header Pin B Grain header Pin E Draper header Pin B Pick up header Pin E Programmable header Pin B