Case IH AFX8010 — FEEDING Feeder housing

CROP PROCESSING - FEEDING Feeder housing FEEDING Feeder housing - Remove (K.25.E - F.10.A.10) AFX8010 The feeder house can be removed from the combine as a complete unit to gain access to the threshing rotor or other components located behind the feeder house. Most components on the feeder house can be serviced or replaced without removing the feeder house, with the exception of the pivot shaft. 1. Raise the feeder housing and secure the safety lock on the feeder lift cylinders. WARNING M421 - Always raise the feeder all the way up and set the lift cylinder safety stand before working under the feeder or header. 40030317 1 2.

Place suitable jack stands under the front of the feeder housing, to support the assembly while disconnecting the cylinders. 40030040 2 3. Disengage the safety lock on the feeder lift cylinder. Lower the feeder housing onto the jack stands. 4. Working from the side of the feeder house, remove the cotter pins (1) securing the front retaining pin (2) for each lift cylinder in the feeder house. Remove each pin and lower the lift cylinders to the ground. 40030039A4 3 9712 1 27/05/2004 K.25.E / 6