Case IH AFX8010 — FEEDING Feeder housing

CROP PROCESSING - FEEDING Feeder housing 11. Install the four smaller bolts (1) that connect the universal joint to the feeder input shaft yoke. Torque to 61 - 81 Nm ( 45 - 60 lb ft ). 10030325A4 9 12. Install the four larger bolts (2) through the universal joint connecting the main feeder drive shaft (3) and the feeder input shaft (4) . Torque to 132 - 157 Nm ( 97 - 116 lb ft ). 13. Install the feeder position sensor (1) found on the right side of the feeder housing. Install the bolt (2) into the position sensor bracket (3) . Insure the sensor wiper is not binding. If it is, shim as necessary. Reconnect the connector (4) for the feeder position sensor (1) . 14.

Reconnect the two plug connectors (1) to the wire harness. 40030324B4 10 10030322A4 11 9712 1 27/05/2004 K.25.E / 13