CROP PROCESSING - FEEDING Feeder housing 4. The plate on the input shaft side will remove from its gasket fairly easily. 10034613 4 5. The cover (1) on the output shaft side will be sealed tight to the housing because of its O ring seal. To remove the bearing in the cover (1) use a slide hammer or small pry bar and work your way around the bearing evenly. 10034608A5 5 6. With both covers off remove the snap ring (1) from the center shaft (2) on the output shaft side. 7. Remove the bearing (1) behind the snap ring using a set of pullers. 10034614A5 6 10034616A5 7 9712 1 27/05/2004 K.25.E / 28