Case IH AFX8010 — FEEDING Feeder housing

CROP PROCESSING - FEEDING Feeder housing 8. Remove the retaining ring (1) from behind the bearing. 10034617A5 8 9. On the straight through input shaft you must remove the oil seals on both sides using a seal puller. NOTE: The seals will need to be replaced. Do not try to reuse the removed seals or leakage could occur causing gearbox damage and failure. 10034619 9 10. Behind the seals (1) remove the snap ring (2) and shims from both ends of the shaft. 11. Note to keep track of the number of shims (1) and the orientation of where you removed them. 10034619A5 10 10034620A5 11 9712 1 27/05/2004 K.25.E / 29