CROP PROCESSING - FEEDING Feeder housing 12. To remove the straight through input shaft you can either use a press if one is available, or a large soft face dead blow hammer. 10034622 12 13. The shaft must be removed with the beveled spur gear end out first from the housing. 10034623 13 14. With the shaft out, the bearing (1) on the shaft can be removed using a set of pullers or the press. 15. The remaining bearing (1) in the housing may be removed in a press or by using a long soft drift and a dead blow hammer driving it from the inside of the housing out. 10034622A5 14 NOTE: Keep track of the number and orientation of shims (2) . 10034624A5 15 9712 1 27/05/2004 K.25.E / 30