CROP PROCESSING - FEEDING Feeder housing 5. Install the bearings onto the output shafts (1) for the conveyor and rock trap drives. This is done by a press using the correct tube to fit over the shaft. Be sure tube contacts the inner race of the bearing only when pressing onto the shaft so bearing damage will not occur. 10034632A5 4 6. With the drive gears in place install the output shafts (1) by first aligning the splines, and then pressing until they are seated in the housing. 10034633A5 5 7. Install the shims. (1) 8. Install the retaining ring. (1) 10034631A5 6 10034630A5 7 9712 1 27/05/2004 K.25.E / 36