CROP PROCESSING - FEEDING Feeder housing 9. Rotate the shafts (1) by hand to assure no binding before proceeding further. 10034629A5 8 10. Using a caliper or dial gauge and check the position of the gear with reference to the speed sensor spot-facing in the housing. The dimension should be 26. 3 mm (+0.10/-0.30mm). 50034947 9 11. A dial indicator can also be used instead of the caliper. 50034948 10 12. Install the ball bearing (1) into the support in the housing for the torque limiter center shaft and gear cluster. Press the bearing into the housing until it is seated. 10034627A5 11 9712 1 27/05/2004 K.25.E / 37