CROP PROCESSING - FEEDING Feeder housing Feed chain - Tension adjust (K.25.E.48 - F.45.A.40) AFX8010 1. Completely lower the feeder to the ground. 2. Rotate the chain so that a feed slat (1) is aligned with the bottom of the drum (2) . If the feeder drum is in the low position, measure the clearance between slat and floor at the first slat behind the feeder drum. If the feeder drum is in the mid position, measure the clearance between slat and floor at the second slat behind the drum. If the feeder drum is in the high position, measure the clearance between slat and floor at the third slat behind the drum. Adjust the clearance to 0.8 - 3.2 mm ( 1/32 - 1/8 in ). NOTE:
When adjusting the feeder chain, make sure the feed slats will not come in contact with the front shield (3) . If contact is made remove links from chains and readjust. 10032078D5 1 3. To tighten the chain, loosen nuts, (1) on each side of the feeder and jam nuts (2) . Turn nuts, (3) against supports (4) evenly on each side until proper tension is obtained, then tighten jam nuts (2) and nuts (1) . 10034667C5 2 4. To loosen the chain, loosen nuts (1) on each side of the feeder and jam nuts (3) . Turn nuts, (2) against supports (4) evenly on each side until proper tension is obtained, then tighten jam nuts (3) and nuts (1) . 10034667C5 3 9712 1 27/05/2004 K.25.E / 42