CROP PROCESSING - FEEDING Feeder housing Feed chain - Replace (K.25.E.48 - F.10.A.30) AFX8010 DANGER M184D - ALWAYS shut OFF engine, remove the key and engage feeder safety lock in position on lift cylinder before working under header or feeder. Failure to engage feeder safety lock may cause injury or death. 1. Rotate the chain until the connection links are visible at the front of the feeder. 2. Loosen the chain as described in Feed chain - Tension adjust (K.25.E.48 - F.45.A.40) . 3. Remove the connection links (1) . Connect the new chain to the old chain at the bottom of the drum and pull the old chain out from the top of the drum, while feeding in the new chain.
When the old chain is removed from the feeder, disconnect the other end of the old chain and connect both ends of the new chain together with the connection link (1) . IMPORTANT: Be sure that chains engage both rear sprockets evenly to assure the feeder slats are square to the cross shaft. 10032078A5 1 4. Tighten the chain as described in Feed chain - Tension adjust (K.25.E.48 - F.45.A.40) . 5. To replace a feed slat (1) , remove the bolts and nuts (1) . Remove the feed slat (2) . Install the new feed slat (2) making sure that the taller edge (or serrated edge if equipped) is on the leading side of the chain. Secure with bolts and nuts (1) . Torque bolts to 77 - 87 Nm ( 56 - 64 lb ft ).
10032081A5 2 9712 1 27/05/2004 K.25.E / 43