Case IH AFX8010 — FEEDING Feeder housing

CROP PROCESSING - FEEDING Feeder housing Sensing system Speed sensor - Open circuit (K.25.E.95.80 - G.30.B.50) AFX8010 E0014-05 - Feeder Speed Sensor Cause: The feeder RPM sensor (B14) circuit is disconnected. Possible failure modes: 1. Sensor supply, signal or ground wiring is disconnected. 2. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "FEEDER" sort menu, and select "SPD SEN" to check the voltage range.

The proper voltage sensor blocked by ferrous metal - 5.6 - 7.3 volts The proper voltage sensor unblocked by ferrous metal - 0.5 - 5.6 volts If there is an open in the supply, signal or ground wiring the voltage will read 7.3 - 9.0 volts . A. If the voltage reading is high indicating an open, continue with Step 2 . 2. Disconnect the feeder RPM sensor connector X284 . Install a jumper wire between pins A (orange) and B (yellow) on connector X284 . B. If the voltage reading is within the proper limits, continue the troubleshooting at Step 6 . A. If the voltage rises to > 9 volts , continue with step 3 . B. If the voltage remains 7.3 - 9.0 volts , continue with Step 7 . 3.

Disconnect the feeder RPM sensor connector X284 . Install a jumper wire between pins B (yellow) and C (blue) on connector X284 . A. If the voltage drops to 0 - 0.5 volts the open is in the sensor, or sensor wiring. Replace the sensor. B. If the voltage remains out of range, continue with Step 3 . 4. Remove the jumper wire from connector X284 . Use a multimeter to check for continuity between pin C (blue) on connector X284 and chassis ground. A. If no continuity is found, continue with Step 4 . B. If continuity is found, continue with Step 5 . 5. Disconnect connector X007 . Use a multimeter to check for continuity between pin 28 on connector X007 and chassis ground. A.

If no continuity is found, continue with step 6 . B. If continuity is found, there is an open circuit in the feeder (FE) harness between connector X007 and X284 wire 1201 black/white. Locate the open and repair. 6. Disconnect connector X008 . Use a multimeter to check for continuity between pin 28 on connector X008 and chassis ground. A. If continuity is found, there is an open circuit in the front frame (FF) harness between connector X007 and connector X008 wire 1201 black/white. Locate the open and repair. 9712 1 27/05/2004 K.25.E / 92