Case IH AFX8010 — FEEDING Feeder housing

CROP PROCESSING - FEEDING Feeder housing B. If no continuity is found, there is an open circuit in the main frame (MF) harness between connector X008 and clean battery ground #6 wire 1201 black/white. Locate the open and repair. 7. Remove the jumper wire from connector X284 . Check and confirm that fuse F-45 is good. Use a multimeter to check for 12 volts at connector X089 pin A (orange). A. If no voltage is found, continue with Step 8 . B. If 12 volts is found, continue with Step 5 . 8. Disconnect connector X007 . Use a multimeter to check for voltage at connector X007 pin 26. A. If no voltage is found, continue with Step 9 . B.

If 12 volts is found, there is an open circuit in the feeder (FE) harness between connector X007 and connector X284 wire 1260 orange. Locate the open and repair. 9. Disconnect connector X008 . Use a multimeter to check for voltage on the main frame (MF) harness end of connector X008 pin 18. A. If no voltage is found, continue with Step 10 . B. If 12 volts is found, there is an open circuit in the front frame (FF) harness between connector X007 and connector X008 wire 1260 orange or 1205 orange. Locate the open and repair. 10. Disconnect connector X005 . Use a multimeter to check for voltage on the cab main (CM) harness end of connector X005 pin 5. A.

If no voltage is found, there is an open circuit in the cab main (CM) harness between connector X005 and fuse F45 wire 013 orange. Locate the open and repair. B. If 12 volts is found, there is an open circuit in the main frame (MF) harness between connector X005 and connector X008 wire 1205 orange or 013 orange. Locate the open and repair. 11. Disconnect connector X007 . Install a jumper wire between pins 7 and 28 on connector X007 . A. If the voltage drops to 0 - 0.5 volts there is an open circuit in the feeder (FE) harness between connector X007 and X284 wire 489 yellow. Locate the open and repair. B.

If the voltage remains at 7.3 - 9.0 volts , there is an open circuit in the front frame (FF) harness between connector X007 and connector X020 J3-14 wire 489 yellow. Locate the open and repair. 12. Visually inspect harness and connectors for damage, bent or dislocated pins, corroded terminals or broken wires. A. If no damage is found erase fault code and continue operation. 9712 1 27/05/2004 K.25.E / 93