Case IH AFX8010 — THRESHING Axial flow threshing

CROP PROCESSING - THRESHING Axial flow threshing Rotor RPM Sensor, B-01 - The rotor RPM sensor, located in the rotor gear case housing, is used by the CCM3 module to calculate the rotor’s actual speed. Ring-to-Frame Solenoid, L-46 - The ring-to-frame brake, mounted on the side of the rotor control valve body, is used to connect the rotor motor drive to the POWER PLUS output shaft, permitting the rotor to be driven by the rotor motor independent of the engine-input shaft. The Ring-to-Frame is used: 1. While starting the rotor from a disengaged mode, to bring it up to a speed that will match the current engine speed. Also during rotor de-slug mode for reversing. 2.

To assist during a controlled deceleration of the rotor when the separator is disengaged. 3. To prevent rotor rotation due to viscous drag when the separator is disengaged (idle state). Engine-to-Ring Solenoid, L-45 - The engine-to-ring clutch, mounted on the end of the rotor control valve body, is used to connect the engine input to the POWER PLUS output shaft, permitting the rotor to be driven by the engine. This permits only one preset output speed from the POWER PLUS drive. Concave Increase/Decrease Control, S-16 - The Concave control switch, located on the right-hand console, provides the operator with a method of changing the clearance between the rotor and the concave grates.

The range is from 0, against the stop bolts, to 24, fully open. Concave Position Sensor, R-07 - The Concave Position sensor, located on the left side of the upper chassis in front of and attached to the torsion bar of the concave cage, used to inform the operator through the UD+ the clearance of the concave. The sensor is also used to position the concave when a Harvest Preset is used. Concave Motor, M-04 - The Concave motor, located on the left side of the upper chassis over the torsion bar of the concave cage, is the actuator that moves the concave grates to provide the concave clearance. 9714 1 27/05/2004 K.40.C / 13