CROP PROCESSING - THRESHING Axial flow threshing Drive system Drive and gear - Leakage test (K.40.C.40.44 - F.40.A.40) AFX8010 10041864 1 1. In order to prevent any leak of oil perform the following test: Using a plug on the input shaft side of the gearbox place a pressure gauge. Be sure the gauge is sealed good around the threads with thread sealant. Use a gauge capable of reading 0 - 207 kPa ( 0 - 30 psi ) increments accurately. Using the plug in the housing on the shift fork side of the gearbox induce service air into the gearbox to pressurize it to 0.35 bar (5 psi ) .
By watching the gauge or by using a manometer (scale about 0.6 bar) watch for a pressure drop over a ten minute period, this will verify seal integrity of the gearbox for leaks. 10041865 2 9714 1 27/05/2004 K.40.C / 21