CROP PROCESSING - THRESHING Axial flow threshing Drive system Drive and gear - Install (K.40.C.40.44 - F.10.A.15) AFX8010 1. Block the rear of the rotor so that the coupler is in the center of the hole where the rotor gearbox shaft goes. NOTE: Through the access door in the grain tank, the rotor access panel (1) can be removed and used for aid in the install process if needed. 10030051A4 1 2. Lower the gearbox into the cavity between the engine and the grain tank sideways on an overhead hoist. 10041864 2 3. Install the gearbox so the shaft and coupler splines mesh. 4. Line up the mounting holes and install the six M16 x 60 rotor gearbox bolts. Torque the bolts to 354 Nm ( 261 lb ft ). 5.
Install the driveshaft (2) to the gearbox and use a small bar (1) to hold the shaft from turning when tightening the eight M10 x 45 bolts. Torque the bolts to 57.3 Nm ( 42.3 lb ft ) 6. Install the drain tube. 50034647A5 3 7. Install the gearbox shift cable and linkage. 9714 1 27/05/2004 K.40.C / 22