CROP PROCESSING - THRESHING Axial flow threshing Control valve Clutch control valve - Short circuit to B+ (K.40.C.14.20 - G.30.B.54) AFX8010 E0306-03 - Rotor ETR Clutch Current Sense Context: The Rotor ETR Clutch Current Sense circuit is the ground path for the Rotor ETR clutch PWM solenoid L-45. By monitoring current flow on the return path of the Rotor ETR clutch solenoid, the module can provide precise control of the solenoid engagement. When this error message is reported, this is an indication of excessive current draw on the circuit, or a result of a high voltage short on the return line. Cause:
The Rotor ETR clutch solenoid (L-45) circuit has excessive current draw, or is shorted to a high voltage source. Possible failure modes: 1. Bad solenoid. 2. Return side wiring shorted to 12 volts . 3. Controller internal failure (internal regulator failure). Solution: 1. Start the combine engine. Enter the Universal Display Plus "DIAG" screen. Select the "THRESHING" or "ROTOR" sort menu, and select "ETR CTCH ISENSE" to monitor the current flow. Use the "COMMAND" and "ENGAGE" functions to power the circuit at 100% output. The proper Rotor ETR clutch solenoid current should be approximately 1.0 - 1.5 amps . The fault code is triggered by current flow greater than 3.3 amps . A.
If the reading is greater than 3.3 amps , continue with Step 2 . B. If the reading is normal ( 1.0 - 1.5 amps ), continue the troubleshooting at Step 8 . C. If there is no current reading, the module may have failed as a result of a 12V short on the Isense circuit. Continue with Step 5 . NOTE: If the current reading is high, immediately shut off the circuit by pressing the "ENGAGE" key after verifying the reading to prevent module damage. 2. Turn the key switch to the OFF position and disconnect the Rotor ETR clutch solenoid connector X410 . Use a multimeter to check the resistance of the Rotor ETR clutch solenoid L-45 between connector X410 pins A & B.
The proper resistance range for the Rotor ETR clutch solenoid is 7.2 - 11.2 ohms . A. If out of specification, replace the solenoid. Continue with Step 7 . B. If the coil is within specification, continue with Step 3 . 3. Disconnect connector X011 . Use a multimeter to check the resistance of the Rotor ETR clutch solenoid circuit between connector X011 pins 4 & 26. The resistance should be the same as, or slightly higher than the resistance of the solenoid as measured in Step 2 A. If the resistance is lower than the previously measured resistance, there is a short in the harness between connector X410 and connector X011 wires 1048 white and 1062 blue. Locate the short and repair.
Continue with Step 7 . B. If the resistance is the same as previously measured, continue with Step 4 . 4. Disconnect connector X034A . Use a multimeter to check the resistance of the Rotor ETR clutch solenoid circuit between connector X034A pins 5 & 8. The resistance should be the same as, or slightly higher than the resistance of the solenoid as measured in Step 2. 9714 1 27/05/2004 K.40.C / 75