CROP PROCESSING - THRESHING Axial flow threshing 6. Disconnect connector X410 . Use a multimeter to check the resistance of the Rotor ETR clutch valve coil between connector X410 pins A & B. The proper resistance range is 7.2 - 11.2 ohms . A. If there is no continuity, replace solenoid. B. If the coil is within specification, continue with Step 6 . 7. Use a multimeter to check for continuity between connector X410 pin B (harness side) and chassis ground. Flex the gearbox (GB) harness between the clutch valve and connector X011 while making this check. A. If there is no continuity to ground, continue with Step 7 . 8. Disconnect connector X011 .
Use a multimeter to check for continuity between connector X011 pin 26 and chassis ground. Flex the main frame (MF) harness between the connector X011 and connector X034A while making this check. B. If there is continuity to ground, continue with Step 9 . A. If there is continuity to ground, the open circuit is in the gearbox (GB) harness between connector X011 and connector X410 wire 1062 blue. Locate the open and repair. B. If there is no continuity to ground, continue with Step 8 . 9. Disconnect connector X034A . Use a multimeter to check for continuity between connector X034A pin 8 and chassis ground.
Flex the main frame (MF) harness between the connector X034A and connector X013 while making this check. A. If there is continuity to ground, the open circuit is in the main frame (MF) harness between connector X011 and connector X034A wire 1062 blue. Locate the open and repair. B. If there is no continuity to ground, continue with Step 8 . 10. Disconnect connector X013 on the bottom of CCM1 module. Use a multimeter to check for continuity between connector X013 pin J2-40 on the module and chassis ground. A. There is infinite resistance. The sense resistor in the CCM1 module has failed. Replace the module. B.
There is less than 1 ohms resistance, indicating the sense resistor in the CCM1 module is okay. The open circuit is in the expansion (EX) harness between connector X034A and connector X013 wire 1062 blue. Locate the open and repair. NOTE: The sense resistor in the module for the Isense Rotor ETR Clutch circuit is easily damaged as a result of excessive current draw or a short to high voltage. 11. Turn the key switch to the ON position. Use the Universal Display Plus "DIAG" screen controls to manually power the Rotor ETR clutch valve. Use a multimeter to check for 12 volts between connector X410 pin A and chassis ground. A. If 12 volts is not present, continue with Step 10 . B.
If 12 volts is found, continue with Step 11 . 12. Turn the key switch to the ON position. Use the Universal Display Plus "DIAG" screen controls to manually power the Rotor ETR clutch valve. Use a multimeter to check for 12 volts between connector X011 pin 4 and chassis ground. A. If 12 volts is present, the open circuit is in the gearbox (GB) harness between connector X410 pin A and connector X011 pin 4 wire 1048 white. Locate the open circuit and repair. B. If 12 volts is not present, continue with step 13 . 13. Turn the key switch to the ON position. Use the Universal Display Plus "DIAG" screen controls to manually power the Rotor ETR clutch valve.
Use a multimeter to check for 12 volts between connector X034A pin 5 and chassis ground. A. If 12 volts is present, the open circuit is in the main frame (MF) harness between connector X034A and connector X011 pin 12 wire 1048 white. Locate the open circuit and repair. 9714 1 27/05/2004 K.40.C / 80