Case IH AFX8010 — THRESHING Axial flow threshing

CROP PROCESSING - THRESHING Axial flow threshing B. If 12 volts is read, there is an open circuit in the main frame (MF) harness between connector X034A and connector X011 wire 1049 white. Locate the open and repair. 7. Disconnect connector X011 . Use the multimeter to check for continuity between connector X011 pin 27 and chassis ground. A. If continuity is found, continue with step 8 . B. If no continuity is found, the short to ground is in the gearbox (GB) harness between connector X011 and connector X409 wire 1049 white. Locate the short and repair. 8. Disconnect connector X034A . Use the multimeter to check for continuity between connector X034A pin 9 and chassis ground. A.

If continuity is found, the short to ground is in the expansion (EX) harness between connector X034A and connector X020 J3-3 wire 1049 white. Locate the short and repair. B. If no continuity is found, the short to ground is in the main frame (MF) harness between connector X034A and connector X011 wire 1049 white. Locate the short and repair. 9. Visually inspect the harness and connectors for damage, bent or dislocated pins, corroded terminals or broken wires. A. If no damage is found, erase the fault code and continue operation. 9714 1 27/05/2004 K.40.C / 85