Case IH AFX8010 — THRESHING Axial flow threshing

CROP PROCESSING - THRESHING Axial flow threshing 6. Disconnect connector X456 . Use a multimeter to check for continuity between connector X189 pin 2 and connector X456 pin 5. A. If continuity is found, continue with step 6 . B. If no continuity is found, there is an open circuit in the main frame (MF) harness between connector X189 pin 2 and connector X456 pin 5 wire 411 yellow. Locate the open and repair. 7. Carefully disconnect connector X019 from the bottom of CCM1 module. Use a multimeter to check for continuity between connector X456 pin 5 and connector X019 pin J2-19. A. If continuity is found, the open is in the sensor. Replace the sensor. B.

If no continuity is found, there is an open circuit in the main frame (MF) harness between connector X456 pin 5 and connector X019 pin J2-19 wire 411 yellow. Locate the open and repair. 8. Operate the machine while monitoring the Universal Display Plus "DIAG" screen. A. If no low out of range readings are indicated, erase the fault code and continue operation. 9714 1 27/05/2004 K.40.C / 116