Case IH AFX8010 — STORING AND HANDLING Grain storing

CROP PROCESSING - STORING AND HANDLING Grain storing Bubble-up auger drive system - Assemble (K.60.B.40 - F.10.A.20) AFX8010 When pressing bearings on to shafts, press on bearing inner races only, to avoid damaging the bearings. 1. The gearbox assembly consists of two very similar 90 ° bevel gear boxes. Many operations for the second box are identical to that for the first box. Input and output shafts are assembled with the same parts and procedures. Each gear set requires its own shimming, however. Assemble previously removed shims (1) to inboard end of shaft and press bearing (2) on. Assemble key (3) in shaft keyseat and press on gear (4) .

Assemble previously removed shims (5) and press on bearing (6) . Apply a film of grease to seal (7) lip and slide on shaft with lip pointing toward bearing. Clean all grease off O.D. of seal. 20041760A5 1 2. Assemble cover plates (1) and oil seals (2) on shaft (3) having first coated seal lips with grease. Seal lips must point away from each other, toward the center of each box. Keep seal O.D. free of grease. Assemble retaining rings (4) and shims (5) . Press bearings (6) in position against shims and retaining ring, having first put a film of Loctite 603 between bearing and shaft. Assemble another bearing (7) and shims (8) , place keys (9) in keyseat and press gears (10) on.

Assemble shims (11) and retaining rings (12) and lightly press bearing, shim and gear back against retaining ring to remove all clearance. 20041756A5 2 3. Place shafts in housing halves and shim as required to achieve required backlash of 0.15 - 0.49 mm ( 0.006 - 0.019 in ) and tooth contact patterns as shown in shaded area on all gear sets. In the figure, is the length of the gear tooth. 10041889A5 3 9716 1 27/05/2004 K.60.B / 7