Case IH AFX8010 — STORING AND HANDLING Grain storing

CROP PROCESSING - STORING AND HANDLING Grain storing 4. After the shimming is finalized, apply a film of silicone sealant around the housing borders, including the bores (1) for the shaft seals. Assemble the pre-assembled input (2) and output (3) shafts in a housing half. 20041755A5 4 5. Assemble the pre-assembled shaft (1) into the housing halves (2) . Apply a light film of silicone sealant to the O.D. of exposed halves of the four oil seals. 20041757A5 5 6. Assemble the top halves of the housings after applying a film of silicone sealant to the shaft seal bores. Install sixteen bolts and nuts (1) loosely.

To ensure alignment of the halves, install the two oring plugs (2) three threads deep before tightening the sixteen housing bolts to 24 - 31 Nm ( 18 - 23 lb ft ). Assemble plates (3) on input and output shafts and fasten with bolts and nuts (4) . Tighten to 10 - 13 Nm ( 90 - 115 lb in ). Tighten the two plugs (2) to 9.8 Nm ( 87 lb in ). Install two of the fill and drain plugs (5) and tighten to 9.8 Nm ( 87 lb in ). 20041758A5 6 9716 1 27/05/2004 K.60.B / 8