CROP PROCESSING - STORING AND HANDLING Grain storing 5. Remove two cap screws and lock washers (1) from front of right hand fan drives area screen. Set screen aside for use in re-assembly. 40033205A5 4 6. Loosen the nut (1) to raise the idler (2) and remove chain from bubble-up auger drive. 10034840C5 5 7. Remove cover (1) . 10034685A5 6 8. If equipped, disconnect wire harness (1) . Remove four (4) cap screws, lock washers and nuts (2) and remove sensor plate assembly. Feed wire harness out through the grommet hole in grain tank to the rear of this connection. 50030166A5 7 9716 1 27/05/2004 K.60.B / 24