Case IH AFX8010 — STORING AND HANDLING Grain storing

CROP PROCESSING - STORING AND HANDLING Grain storing 12. Remove two cap screws and lock washers (1) from front of right hand drives area screen. Set screen aside for use in re-assembly. 40033205A5 11 13. Remove two cap screws (1) from bracket (2) near the bottom of the elevator and cap screw (3) . Remove cap screw (4) and loosen two others at top of angle bracket (5) from elevator housing. Swing bottom of bracket away to disengage notch in bracket from flanges of elevator housing and lower body. 40033226A5 12 14. Remove three cap screws, lock washers, and nuts (1) on right hand side and three of same on rear flange.

Loosen four cap screws with nuts and washers (2) to loosen clean grain cross auger tube halves. Lower body housing can now be pulled outward, away from the cross auger, the sprocket and spacer sliding off the shaft as the housing is moved outward. 40033209C5 13 15. To Remove the Upper Shaft of the grain elevator, proceed as follows: 9716 1 27/05/2004 K.60.B / 37