CROP PROCESSING - CLEANING Primary cleaning 5. Starting with the left hand side of the fan assembly install the flange bracket (1) , bearing (3) , and flangettes (2) with the four M12 x 35mm bolts to clamp the bearing in place. Install the lock collar (4) and tighten in the direction of rotation. 50042973A5 5 6. On the right hand side of the fan assembly install the flange bracket (1) , bearing (4) and flangettes (2) . Install the sensor bracket (3) to the bearing flangette (2) , and then the four M12 x 35mm bolts and the pickup gear lock collar (5) . NOTE: From the end of the pickup lock collar (5) to the flange bracket (1) the dimension should be 68 - 70 mm ( 2.68 - 2.75 in ) .
50042972A5 6 7. Install the lock collar with the speed sensor pickup, and tighten in the direction of travel. Adjust the speed sensor with a 1 - 2 mm ( .039 - .078 in ) air gap. 8. The pickup gear must be placed on the shaft with a 68 - 70 mm ( 2.68 - 2.75 in ) gap (1) from the end of the pickup gear to the outside of the bearing support bracket. 10041929 7 50043062A5 8 9717 1 27/05/2004 K.62.B / 38