CROP PROCESSING - CLEANING Primary cleaning Motor Shoe leveling motor - Short circuit to B+ (K.62.B.28.60 - G.30.B.54) AFX8010 E0032-03 - Sieve Angle Sensor Cause: The shoe leveling actuator M-03 position sensor circuit is shorted to high voltage, or the sensor ground is open. Possible failure modes: 1. Sensor supply or signal wiring is shorted to high voltage ( 12 volts ). 2. Sensor ground wiring is open. 3. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "CLEANING" sort menu, and select "SIEVE ANG SEN" to check the voltage range. The normal operating voltage range is 0.3 - 5.2 volts . A.
If the voltage reading is high (> 5.2 volts ), continue with step 2 . B. If the voltage reading is within the proper limits, the circuit may not be shorted at this time. Continue the troubleshooting at step 11 . NOTE: Visually inspect the wiring harness and connectors. Verify that the connectors are fully installed. Inspect the terminals and wires at the connector for pushed back or corroded terminals or damaged wires. Flex the harnesses involved to reveal intermittent breaks or shorts in the wiring concerned. 2. Key off. Disconnect connector X088 , and use a multimeter to test for continuity to ground on connector X088 pin B. There should be low resistance ( 1 ohms ) to ground. A.
If continuity is found ( 1 ohms ), continue with step 6 . B. If no continuity is found, or if there is high resistance to ground, continue with step 3 . 3. Key off. Disconnect connector X023 . Use a multimeter to test for continuity between connector X023 pin 16 and chassis ground. There should be low resistance ( 1 ohms ) to ground. A. If no continuity is found, or if there is high resistance to ground, continue with step 4 . B. If continuity is found, there is an open circuit in the lower frame (LF) harness between connector X088 pin B and connector X023 pin 16 wire 724 or 723 blue. Locate the open and repair. 4. Key off. Carefully remove connector X020 from the bottom of CCM1.
Use a multimeter to test for continuity between connector X023 pin 16 and connector X020 pin J3-18. There should be low resistance ( 1 ohms ). A. If continuity is found, continue with step 5 . B. If no continuity is found, there is an open circuit in the front frame (FF) harness between connector X023 pin 16 and connector X020 pin J3-18 wire 723 blue or 501 blue. Locate the open and repair. 5. Key off. Use a multimeter to test for continuity between connector X020 pin J3-18 on CCM1 and chassis ground. There should be low resistance ( 1 ohms ) to ground. A.
If no continuity is found, or there is high resistance to ground, the CCM1 module is not supplying a ground path for the sensor due to an internal failure. Replace the CCM1 module. B. If continuity is found, the ground path for the sensor tests okay. Reconnect all connectors and retest for continuity to ground at step 2 . 6. Disconnect connector X088 , and use a multimeter to test for voltage on connector X088 pin C. There should not be any voltage present. 9717 1 27/05/2004 K.62.B / 74