CROP PROCESSING - RESIDUE HANDLING Spreader 6. Disconnect the unload tube cradled sensor connector X240 . Use a multimeter to check for continuity between the harness end of connector X240 pin 1 and chassis ground. A. If there is continuity, the ground path for the sensor is complete, and the fault is in the sensor itself. Replace the sensor. 7. Disconnect the straw hood rear (SH) harness from the straw hood front (SW) harness at connector X071 . Use a multimeter to check for continuity between the straw hood front (SW) harness end of connector X071 pin 12 and chassis ground. B. If there is no continuity, continue with Step 7 . A.
If there is continuity, the open circuit is in the straw hood rear (SH) harness between connector X071 and the connector X240 pin 1, wire 482 blue. Locate the open and repair. B. If there is no continuity, continue with Step 8 . 8. Disconnect the straw hood front (SW) harness from the main frame (MF) harness at connector X024 . Use a multimeter to check for continuity between the main frame (MF) harness end of connector X024 pin 11 and chassis ground. A. If there is continuity, the open circuit is in the straw hood front (SW) harness between connector X071 and the connector X024 wire 482 blue or 461 blue. Locate the open and repair. B.
If there is no continuity, the open circuit is in the main frame (MF) harness between connector X024 and connector X019 pin J2-14 wire 461 blue, 401 blue or 460 blue. Locate the open and repair. 9. Turn the key to ON position. Observing the LED on the harness end side of the sensor, place ferrous metal in front of sensor then remove. A. The sensor is functioning if LED changes state. Adjust the sensor clearance to 3 mm (1/8"). Erase the fault code and continue operation. 9721 1 27/05/2004 K.64.D / 15