CROP PROCESSING - UNLOADING Grain unloading 5. Subassemble the clutch piston (1) by inserting the smaller o-ring and small seal (2) into the groove in the ID of the piston. Install the larger o-ring and larger seal (3) into the groove on the piston OD. 10035840A5 5 6. Size the inner seal and outer seal on the clutch piston (2) , lube both seals. Press the piston onto the clutch shaft with the tool installed (1) until the piston is fully seated into the clutch housing (3) . 10041891A5 6 7. Place the return spring (3) over the shaft and into the piston. Drop the spring retainer (4) (lip towards spring) and retain on shaft with external snap ring (5) (narrow side up).
This will require pressure to be applied to the spring. 8. Assemble the clutch pack using four each of the following; separator plate (3) , friction plate (2) and in this order until all are used. After all separator plates and friction plates are in place, seated and aligned place the clutch backing plate (4) on stack and retain with backing plate retaining ring (5) (narrow side up). Be sure retaining ring (5) is fully seated into the groove. 10035841A5 7 10035842A5 8 9723 1 27/05/2004 K.72.B / 11