CROP PROCESSING - UNLOADING Grain unloading 9. Place thrust bearing race (washer) (1) over shaft against retaining ring. Place bearing (2) side of thrust bearing on washer. 10035843A5 9 10. Install ring clutch lube seal on gear in groove on spline side. Lube the seal. Place gear assembly on shaft, spline into clutch stack. Remove wedge pins. Slide needle roller bearing (3) , inner ring (4) , and another needle bearing (3) over shaft and press down into gear (5) hub. Assemble thrust bearing (7) (smooth side toward gear) thrust bearing race (washer) (6) and retaining ring (8) (narrow side up) onto shaft. Be sure retaining ring (8) seats fully into groove.
Press cone (9) onto shaft end using a driver. Check to see if cone is fully seated. 10035844 10 11. Subassemble shaft brake. Dab petroleum jelly into seal grooves. Apply a large seal and a small seal (1) into indicated grooves on the brake end of the shaft. Make sure seals (1) are not twisted and are fully seated into the grooves. 10035847A5 11 9723 1 27/05/2004 K.72.B / 12