CROP PROCESSING - UNLOADING Grain unloading 9. If the contact pattern is high on the pinion, and low on the bevel gear, remove shims from (4) in figure 5 and add them at (5) in figure 5 , to move the pinion out of mesh with the bevel gear. Repeat steps 4 - 9 as necessary until the backlash and gear contact patterns are correct. 20041764 8 10. Install washer (2) and two keys (1) . ZDA3488A 9 11. Install sprocket (3) . Install washer (2) and bolt (1) . Tighten to 82 - 106 Nm ( 60 - 78 lb ft ). NOTE: : Apply some thread locking compound to the female threads in the shaft to prevent the bolt from loosening. ZDA3487A 10 12. Install seal (3) . Apply sealing compound and install cover (2) .
Install bolts (1) and tighten them to a torque of 24 - 32 Nm ( 18 - 24 lb ft ). NOTE: Apply some thread locking compound to the tapped holes in the housing to prevent the bolts from loosening. ZDA3486B 11 9723 1 27/05/2004 K.72.B / 34