DISTRIBUTION SYSTEMS - ELECTRICAL POWER SYSTEM To accurately determine the location of a particular circuit, use the index to locate circuits by component label. A table following each frame lists all devices shown on that frame, with their label. In most cases, circuits are contained completely within the frame. However, in some cases, wires can cross frame borders to the previous or next frame. 1 20020068 2 Power runs across the top of each frame, while grounds generally occur at the bottom. Labels are used to identify the power supply on the power wires at the top of the frame.
The top wire label “B +12V” indicates this wire is directly supplied by the batteries, while the wires below are supplied by the K26 and K24 relays respectively. Grounds are identified with a circled number, 1, Figure 2, which indicates a specific ground location on the combine. An absence of this circled number indicates that the device is grounded locally. 20013708 There are five grounding locations on the combine, as listed. 3 A minimal number of jumpers, 1, are used to extend circuits to other frames in the schematic. These jumpers are shown as a wire terminating in a square box, with a letter-identifier and a frame number that the wire is jumping to.
To continue following the circuit, flip to the identified frame number, and look for a jumper box with the same letter-identifier. 1 2 Connectors in the schematic are shown as a dotted box around a component, or around connections in a wire, in the case of an inline connector between harnesses. The connector number will be identified in one corner of the box. 200110927 4 A.30 /190B