DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM Signal Circuits The signal circuit pressure may be generated from the following sources: The reel raise, reel fore/aft and unloading auger swing can NOT create a signal. When any of these functions are activated the jammer valve is also activated. The jammer valve is used to direct full pump pressure into the signal line, this causes the PFC pump to go the high pressure standby. A supply side orifice in each valve controls the speed at which these function operated.
Steering Circuit Header Raise Circuit Signal Valve Circuit Lateral Tilt Valve Reel Drive Valve The jammer valve is connected before the orifices that control the actuation speed. As a result, the signal pressure sensed is not the actual working pressure at the cylinder(s), but full system pressure. In this case, no pressure drop is detected and the oil pressure on either side of the flow compensator spool will remain equal. This situation will cause the system to go on high-pressure standby whenever reel raise, reel fore/aft and unloading auger swing are operated.
The steering, header raise, field tracker and reel drive circuits react differently than the reel raise, reel fore/aft and unloading auger swing circuits. This is due to the location of the signal line. The steering, reel drive, terrain tracker and header raise rates are variable by the operator, unlike the other functions, which are not adjustable. For example, the steering speed can be affected by how fast the operator turns the steering wheel. The header raise rate can be increased or decreased by changing the raise rate setting on the Universal Display Plus monitor.
However, the adjustments for speed of reel raise, reel fore/aft and unloading auger swing are set by the size of the orifices in each valve. Within the PFC system there are five checks valves located in the signal lines. One at the header valve, one at the steering priority valve, one in the reel drive valve and two in the lateral tilt valve. The purpose of these checks is to allow the highest signal line pressure to get back to the compensator. This will make sure that the component with the highest-- pressure demand is satisfied.
The signal line for the variable control systems (steering, terrain tracker, reel drive and header raise) is located after each control valve, (monitoring the circuit work pressure). In this location, the signal line will sense actual working pressure in the cylinder(s). A.10.A / 29