DISTRIBUTION SYSTEMS - ELECTRICAL POWER SYSTEM Battery - Replace (A.30.A.83 - F.10.A.30) AFX8010 1. To replace the two 12 volts batteries in the machine start by disconnecting the negative battery terminals (1) . NOTE: Use only OEM recommended 12 volt batteries when replacing with the proper cranking amps. Failure to do so may result in component failure. 10035350A5 1 2. Remove the positive terminals from the batteries. 3. Loosen the bolts on the battery hold down clamp, and remove the clamp from the batteries. 10035350 2 4. Remove the batteries from the machine and replace with new batteries. IMPORTANT: Note that the batteries are heavy, so use caution when handling. 5.
Install the new batteries onto the tray with the negative terminals to the left, or the negative terminals to the front of the machine. connect the positive terminals first. Then connect the negative terminals. IMPORTANT: Always connect the positive terminals first to prevent sparks if accidently grounded to the machine. 6. Install the battery hold down bar across the tops of the batteries. Tighten the bar bolts until the batteries are snug, but be careful to not overtighten the bolts as damage to the battery cases may occur. 9667 1 27/05/2004 A.30.A / 302