DISTRIBUTION SYSTEMS - ELECTRICAL POWER SYSTEM 9667 1 27/05/2004 A.30.A / 304 N° Test Point Expected Result Other Result (Possible Cause) 4 Measure for 12 volts at the B+ terminal of the Alternator while turning on various loads on and off (lights, heater, fan, etc.) Voltage varies between 12.8 - 14.5 volts in response to load applied. If good reading, charging system is operating properly. Alternator Go to test 5 5 Stop Engine, Key switch in OFF position. Measure resistance between alternator housing and engine ground. Less than 1 ohms. If good reading, repair or replace Alternator. High resistance on circuit 803 (BK) from Alternator to engine ground.
Clean surfaces at Alternator and engine block. Ensure that all mountings are clean and tight.