Case IH AFX8010 — LIGHTING SYSTEM

DISTRIBUTION SYSTEMS - LIGHTING SYSTEM Rear work light - Overview (A.40.A.17 - C.10.A.10) AFX8010 The rear work lights illuminate the rear of the combine for better visibility in low light conditions. The rear work lights can be activated in two different ways: Rear Work Light Switch (S-44) turned to the ON position Wiring harness - Electrical schematic frame 40 (A.30.A.88 - C.20.E.40) Combine In Reverse (with front work lights ON). For more information, refer to:

Front work light - Overview (A.40.A.16 - C.10.A.10) REAR WORK LIGHT SWITCH (S-44) Turned to ON Position Wiring harness - Electrical schematic frame 41 (A.30.A.88 - C.20.E.41) If either of the two conditions listed above are met, CCM-1 sends current from connector X018 pin J1-18 to reach pin 1 of the Rear Work Lights Relay (K-31). The ground path for the Rear Work Lights Relay exits pin 2 to reach the Cab Floor Ground location #3. The Rear Work Light Relay energizes and latches pins 3 and 5. The relay sends current from Fuse F-55 through the Rear Work Light Relay and connectors X004 , X024 , and X071 to reach a wire splice. The wire splice splits current into two different paths:

The first path sends current to pin A of the LH Rear Work Light (E-27). The ground path to the LH Rear Work Light exits pin B and travels through a wire splice and connector X071 to reach the Rear Frame Ground Location #1. This causes the work light to illuminate. The second path sends current to pin A of the RH Rear Work Light (E-28). The ground path to the RH Rear Work Light exits pin B and travels through a wire splice and connector X071 to reach the Rear Frame Ground Location #1. This causes the work light to illuminate. 9668 1 27/05/2004 A.40.A / 23