DISTRIBUTION SYSTEMS - LIGHTING SYSTEM Use a multimeter to check for 12 volts between the harness end of connector X033 pin 10 and chassis ground. There should be 12 volts . A. If 12 volts is present, there is an open circuit in the steering column (SC) harness between connector X255 pin 9 and connector X033 pin 10 wire 204 purple. Locate the open and repair. B. If 12 volts is not present, there is an open circuit in the cab main (CM) harness between connector X033 pin 10 and connector X015 pin J1-5 wire 204 purple. Locate the open and repair. 6. Visually inspect the harness and connectors for damage, bent or dislocated pins, corroded terminals or broken wires. A.
If no damage is found, erase the fault code and continue operation. 9668 1 27/05/2004 A.40.A / 38