Case IH AFX8010 — LIGHTING SYSTEM

DISTRIBUTION SYSTEMS - LIGHTING SYSTEM Brake light Switch - Short circuit to B+ (A.40.A.14.83 - G.30.B.54) AFX8010 E0134-03 - Service Brake Pressure Sensor Cause: The brake pressure switch (S-39) circuit is shorted to 12 volts. Possible failure modes: 1. Switch supply wiring shorted to 12 volts . 2. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "BRAKES" sort menu, and select "SERVICE PRESS SW" to check the voltage range. The proper voltage for the brake pressure switch is approximately 8.3 volts - brakes off. The proper voltage range for the brake pressure switch is 1.8 volts or less - brakes on. A.

If the voltage reading is high out of range (> 10 volts ), continue with Step 2 . B. If the voltage is within range, the short may not be present at this time. Continue with Step 3 . NOTE: Visually inspect the wiring harness and connectors. Verify that the connector was fully installed. Inspect the terminals and wires at the connector for pushed back or corroded terminals or damaged wires. Flex the harnesses involved to reveal intermittent breaks or shorts in the wiring concerned. 2. Disconnect the brake pressure switch connector X173 . A. If the voltage drops back into the proper range, the short is in the switch, or switch wiring. Replace the switch. B.

If the voltage remains high, the short circuit is in the main frame (MF) harness between connector X173 and connector X016 pin J2-34 wire 418 yellow. Locate the short and repair. 3. Visually inspect the harness and connectors for damage, bent or dislocated pins, corroded terminals or broken wires. A. If no damage is found, erase the fault code and continue operation. 9668 1 27/05/2004 A.40.A / 47