DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM Electrical Monitoring Circuits Plus monitor. If the pressure falls below specification the park brake indicator lamp will illuminate warning to the operator. The sensor is a variable resistance sensor. Park Brake Pressure Sensor Reference Material: Electrical schematic frames #9, #27 A 5V power is supplied to the sensor from the CCM2 connector X017 terminal J3--26 to the sensor terminal B. The sensor terminal A is directed back to the CCM2 connector X0016 terminal J2--14. The sensor terminal C is providing a variable signal voltage to the CCM2 connector X017 terminal J3--34. Key Components:
Park Brake Sensor B--53, CCM2 A pressure sensor is used to monitor the parking brake release pressure, in turn monitoring the regulated pressure. The sensor provides a constant voltage reading to the CCM2, and the CCM2 places a message on the data bus for the Universal Display NOTE: The diagnostic screen on the Universal Display Plus monitor is monitoring the signal wire C. A.10.A / 40