Case IH AFX8010 — LIGHTING SYSTEM

DISTRIBUTION SYSTEMS - LIGHTING SYSTEM A. If there is continuity to ground, there is a short to ground in the cab roof (CR) harness between connector X133 pin H and connector X127 pin 7 wire 285 purple to the console light E-35.Locate the short and repair. 12. Turn the key switch to the "OFF" position. Use a multimeter to check for continuity between connector X133 pin J and chassis ground. There should be no continuity, or very high continuity to ground, depending on the type of multimeter used.. B. If there is no continuity to ground, continue with step 12 . A.

If there is continuity to ground, there is a short to ground in the cab roof (CR) harness between connector X133 pin J and connector X134 pin 7 wire 286 purple to the washer switch S-38.Locate the short and repair. B. If there is no continuity to ground, continue with step 13 . 13. Turn the key switch to the "OFF" position. Use a multimeter to check for continuity between connector X133 pin M and chassis ground. There should be no continuity, or very high continuity to ground, depending on the type of multimeter used.. A.

If there is continuity to ground, there is a short to ground in the cab roof (CR) harness between connector X133 pin M and connector X128 pin C1 wire 972 purple to the HVAC module A-09/A-20.Locate the short and repair. B. If there is no continuity to ground, continue with step 14 . 14. Remove the tank extensions switch from the cab roof head liner, and unplug connector X125 . Use a multimeter to check for continuity between connector X125 pin 9 and chassis ground. There should be continuity to ground. A. If there is no continuity to ground, remove the cab head liner and check the condition of the cab roof ground 4.

If all switch backlighting ground wires were disconnected from this ground point, this could also generate this fault code. B. If there is continuity to ground, continue with step 15 . 15. Visually inspect the harness and connectors for damage, bent or dislocated pins, corroded terminals or broken wires. A. If no damage is found, erase the fault code and continue operation. 9668 1 27/05/2004 A.40.A / 84