DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM Control / Lubrication Pressure Valve M208003 C M208103 29 5. Filter Base By-Pass IN Port 6. Valve Body 7. Control Pressure Regulating Valve 8. Screen 9. Orifice 11. Lubrication Pressure Regulating Valve 18. Control Pressure Supply 19. Control Pressure OUT Port 20. Lubrication Pressure Switch The Control/Lube pressure control valve regulates both the control pressure and lube pressure. The valve is supplied oil from the control pressure pump at port (18) and is exposed to the regulator (7). The regulator is adjustable to maintain a control pressure of 20--22 bar (290--320 PSI).
If the pressure exceeds the spring setting the valve will shuttle and direct the flow to the return port (RET). The lubrication pressure is checked at the diagnostic test port (20). The lubrication oil is supplied from the lubrication pump, which discussed later in this section. NOTE: The screen and orifice provide for an air bleed on initial start up at the plant or if the system is drained completely. If the orifice was plugged the control pressure pump could have problems priming. It will bleed approximately 1.9 L/m (0.5 GPM) to the PTO gearbox. The valve body also receives the filter by-pass oil at port (5) and combines it with the oil from both pressure regulators.
The combined oil is directed out the return port (RET) to the return filter and back to the PTO reservoir or the lubrication pump. A.10.A / 47