DISTRIBUTION SYSTEMS - ELECTRONIC SYSTEM Sensing system Moisture sensor - Unidentified failure (A.50.A.96.95.80 - G.30.B.46) AFX8010 E0310-11 - Bypass Unit Cause: The sample motor (M-28) engage circuit is open, or shorted to ground. Possible failure modes: 1. Supply wiring damaged. 2. Bad relay in moisture sensor assembly. 3. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "AFS" sort menu, and select "BYPASS MTR". Change the drop-down list to "STATUS", and press the "OFF" button to change the circuit output to "ON". The "STATUS" screen should indicate "OK" if the circuit is working properly. A.
If the status screen indicates "ERROR", the circuit is open or shorted to ground. Continue with Step 2 . B. If the status screen indicates "OK", the circuit is working properly. Continue with Step 6 . 2. Disconnect connector X222 at the sample motor M28. Use a multimeter to check the resistance of the sample motor engage relay between connector X222 pins 2 & 4. The proper resistance range is 65 - 80 ohms . A. If there is zero resistance, the sample motor engage relay is shorted internally. Replace the relay. B. If there is infinite resistance, the sample motor engage relay is open. Replace the relay. C. If the resistance is correct, continue with Step 3 . 3.
Use a multimeter to check for continuity between connector X222 pin 4 (harness side) and chassis ground. Flex the precision farming (PF) harness while making this check. A. If there is continuity to ground, continue with step 4 . 4. Use a multimeter to check for continuity between the expansion (EX) harness end of connector X442 pin 4 and chassis ground. Flex the expansion (EX) harness while making this check. B. If there is no continuity to ground, continue with Step 4 . A. If there is continuity to ground, there is a short to ground in the expansion (EX) harness between connector X442 pin 4 and connector X013 pin J2-13 wire 837 white. Locate the short and repair. B.
If there is no continuity to ground, there is a short to ground in the precision farming (PF) harness between connector X442 pin 4 and connector X222 pin 4 wire 837 white. Locate the short and repair. 5. Use a multimeter to check for continuity between connector X222 pin 2 (harness side) and chassis ground. Flex the precision farming (PF) harness while making this check. A. If there is no continuity to ground, continue with step 6 . B. If there is continuity to ground, continue with Step 5 . 6. Use a multimeter to check for continuity between the expansion (EX) harness end of connector X442 pin 2 and chassis ground. Flex the expansion (EX) harness while making this check. A.
If there is no continuity to ground, there is an open circuit in the expansion (EX) harness between connector X442 pin 2 and front frame ground #2 wire 564 black or 543 black. Locate the open and repair. 9669 1 27/05/2004 A.50.A / 1 19