Case IH AFX8010 — PRIMARY HYDRAULIC POWER SYSTEM

DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM Lubrication System Lubrication Pressure Sensor, (PTO Gearbox) Reference Material: Electrical schematic frames #10 and 26 Electrical Monitoring Circuits The system uses a sensor to monitor the systems operations. Key Components: CCM1, Lubrication Pressure Sensor B--60 Ground Drive Motor Temperature Sensor, (case drain) Reference Material: Electrical schematic frames #08, #26 The lubrication pressure sensor is mounted in the control / lubrication control valve block and is used to monitor the lube pressure to the PTO gearbox components. The sensor provides a constant pressure reading to the CCM1, then places a message on the data bus.

If the pressure goes outside of the normal limits the CCM1 will place a message on the data bus for the Universal Display Plus monitor to display a warning to the operator. The pressure may be monitor on the Universal Display Plus monitor. Key Components: Hydrostatic Motor Temperature Sensor B--46, CCM1 The ground drive motor temperature sensor monitors the oil temperature from the case drain of the ground drive hydrostatic motor. The sensor provides a constant temperature reading to the CCM1, the CCM1 then places a message on the data bus.

If the temperature rises above specification the CCM1 will place a warning message on the data bus for the Universal Display Plus monitor to display, provide a warning to the operator. The temperature may be monitor on the Universal Display Plus monitor. Power (5V) is supplied to the sensor from the CCM1 connector X019 terminal J2--31 to the B terminal and a sensor return (ground) from terminal A back to the CCM1 connector X019 terminal J2--14. The sensor provides a signal from terminal C to the CCM1 connector X019 terminal J2--29. The signal voltage may be monitored on the Universal Display Plus monitor diagnostic screen.

Power is supplied to the sensor from the CCM1 connector X020 terminal J3--31 to the B terminal and the sensors A terminal is directed back to the CCM1 connector X020 terminal J3--18. As the temperature increases the resistance of the sensor decreases, providing for a voltage drop on the supply wire. The signal voltage may be monitored on the Universal Display Plus monitor diagnostic screen. A.10.A / 56