Case IH AFX8010 — ENGINE

POWER PRODUCTION - ENGINE Flywheel - Static description (B.10.A.50 - C.30.A.20) AFX8010 A locating dowel is used to ensure the flywheel is fitted to the crankcase in a single fixed position. The flywheel performs conventional functions (balancing mass, mount for starter ring gear and frictional surface), while also acting as a phonic wheel for a sensor connected to the electronic control unit. For this purpose, fifty-four holes have been made. These are divided into three sectors of eighteen holes each. Each of these sectors is linked to one pair of crankpins (1-6, 2-5, 3-4).

The electronic system does not require the holes to be specially marked, but some ( (1) , (2) , (3) and (4) , lower figure) are notched to allow repairers to carry out certain adjustments and timing settings. The sixth hole of each sector ( (1) , (2) and (3) , lower figure) is marked with a notch. The seventeenth hole of one of the sectors ( (4) , lower figure) is marked with two notches. The angular position of the flywheel at every instant is detected by the EDC control unit by means of an induction sensor ( (1) , upper figure).

The holes marked with notches should be aligned alternatively with the inspection hole ( (2) , upper figure) in the flywheel cover casing during adjustment and timing setting. 20040335 1 9671 1 27/05/2004 B.10.A / 40